- C5 corvette front license plate bracket install#
- C5 corvette front license plate bracket manual#
- C5 corvette front license plate bracket pro#
*A simple one-hand motion to retract and stow the license plate or to pull it out and allow it to swing up into the display position The transport mechanism incorporates a stainless steel torsion spring that both retains the mount in the stored position and also causes it to flip up into the display position when it is manually pulled out. The Show n Go eliminates the standard OEM front license plate mount that often looks like a design after thought, and replaces it with a mount that both displays the plate in a more attractive position, and allow the plate to be retracted and stowed out of site with a simple one hand motion for off road show � no tools or adjustments are required. Show n Go License Plate Transport is an innovative new product that is valued by enthusiasts who take pride in the fundamental clean lines of their automobile.
C5 corvette front license plate bracket manual#
Slide the insert mount back in, tighten bolts and you are done.MOUNT-LICENSE PLATE BRACKET-RETRACTING-MANUAL-EXCEPT Z06 AND GRAND SPORT-97-13 (# E14251)ġ997-2013 CORVETTE C5 & C6 FRONT MANUAL RETRACTING LICENSE BRACKET, EXCEPT Z06 & GRAND SPORT. Temporarily remount bumper cover, trace where the receiver will go through from the back side of the bumper cover, drill your hole. Bolt the main bar where the old support was. To install, simply remove bumper cover, remove bumper support by unbolting on each side.
C5 corvette front license plate bracket pro#
Stroud 430 Pro Stock Pilot Spring Parachute.
Stroud 420 Comp Eliminator Pilot Spring Parachute.Refer to the picture chart above for parachute sizing and specifications. If you are interested in some optional parts with the parachute mount, please check out the links below for info or purchasing.
C5 corvette front license plate bracket install#
Push these with the pre welded hardware through the holes, line up the plate you used for template and install the (6) Nyloc nuts and washers. After drilling your holes, insert the backer plates with welded hard ware from the back side. This can be dangerous and costly.Īfter removing the bumper cover, you will center this parachute plate on the rear bumper support and use the plate as a drill template for your (6) 7/16-20 bolts. This height and location is engineered and integral in making sure the parachute is pulling on the car in line with the center of gravity to insure the rear wheels are not lifted off the ground. This mount comes out of the bumper slightly below the license plate hole. Each part comes powder-coated gloss black. This mount comes fully tig welded and uses CNC laser cut components to create a strong and beautiful component. Our parachute mount is designed to integrate into the factory C5 Corvette bumper support. Stainless Steel Turbo Header Builder Kits.Coyote Ford PCV Fittings and Catch Cans.Coyote Boost / Vacuum Block and Accessories.S10/Sonoma/Blazer Suspension & Brake Products.S10/Sonoma/Blazer Motion Raceworks Products.1982-93 S10/Sonoma/Blazer Motion Raceworks Products.Mustang S197 Suspension & Brake Products.Mustang SN95 / New Edge Tubular Front End Products.Mustang SN95 / New Edge Steering Products.Mustang SN95 / New Edge Suspension & Brake Products.